21
Jan. 2005 RD-700SX
3. Make sure that [EDIT] indicator is extinguished.
If the [EDIT] indicator is lit, press [EDIT] to turn the indicator light off
and put the RD-700SX in normal performance mode.
4. Transmit (play back) the data from the external sequencer.
After playback of the Bulk Dump SETUP data, the RD-700SX writes the data to
the internal memory. Be sure never to turn off the power while this data is
being written (while “Now, writing Bulk Dump Data. Keep on POWER!” is
showing).
For details on transmitting exclusive data, refer to the owner’s manual for your
sequencer.
Play back the external sequencer at the same tempo you used when
performing the bulk dump. If you use a faster tempo, the data may not be
restored correctly.
Data cannot be received if the Device ID of the receiving device differs from
the Device ID used when Bulk Dump was carried out.
FACTORY RESET INSTRUCTIONS
The settings stored in the RD-700SX can be returned to their factory settings.
Executing “Factory Reset All” results in deletion of the Setups . If you want to
keep the recorded content, save the Setup file to your computer or use “Bulk
Dump (Bulk Dump SETUP)” to save it to an external sequencer.
When making USB connections, be absolutely sure to disconnect the USB cable
before starting.
1. Press [EDIT], getting the indicator to light.
The Edit Menu screen appears.
fig.11-01EditMenu2.eps
2. Press CURSOR [ ] to select “9.Utility.”
3. Press [ENTER] to display the Edit screen.
fig.11-02e-Utility.eps
4. Press CURSOR [to display the Edit screen.
While the Factory Reset is in progress, no sounds are produced even when the
keys are pressed. In addition, Rhythms and arpeggios being played are also
stopped.
Factory Reset Current
5. Press [ENTER].
A screen like the one shown below appears.
fig.11-03e-ResetCrnt1.eps
Selecting “000” as the Setup initializes the ONETOUCH [PIANO] and [E.
PIANO] settings.
6. Press [ENTER].
The confirmation message appears.
To cancel the Factory Reset, press [EXIT].
7. Press [ENTER] once again to start the Factory Reset operation.
Never turn off the power during Factory Reset (while “Executing... Don’t
Power Off” appears in the display).
8. After the Factory Reset operation is finished, the Utility screen returns to
the display.
Factory Reset All
5. Press [ENTER].
A screen like the one shown below appears.
fig.11-04e-ResetAll1-1.eps
6. Press [ENTER].
The confirmation message appears.
To cancel the Factory Reset, press [EXIT].
7. Press [ENTER] once again to start the Factory Reset operation.
Never turn off the power during Factory Reset (while “Executing... Don’t
Power Off” appears in the display).
8. After the Factory Reset operation is finished, The Utility screen returns to
the display.
Parameter Value
Factory Reset Curnt The currently selected Setup returned to
their factory settings.
Factory Reset All The settings stored in the RD-700SX can be
returned to their factory settings.
To Next Page
Loading...
