Roland RD-700SX - Instructions for Arranging the Cables

25
Jan. 2005 RD-700SX
Instructions for Arranging the Cables
1. Apply 20-mm and 50-mm width double-sided tape.
→ 20-mm width: Attach beyond the range indicated by arrow B in the figure below (left end: further to the left of the center point between OUTPUT L, R; right end:
further to the right of the 7th key top hole)
→ 50-mm width (in two places): Attach beyond the range indicated by arrow A in the figure below
• Left end: from the OUTPUT L jack to the MIDIJACK connector (aligned with the top edge meeting the edge of the panel riser surface) → Do not peel off the tape
backing!!
• Right end: from LCD holder to SW power section (aligned with the top edge meeting the stud nuts) → Do not peel off the tape backing!!
fig.K-01.eps
40122923 DOUBLE FACED ADHESHIVE TAPE NITTO NO.501F W20MM 20M
40344589 DOUBLE-FACED TAPE #501F W50MM 20M
2. Assembling the PANEL L BOARD
Connect the cables to the following connectors.
Take care to ensure components are connected in the proper orientation.
• 22P to CN1
• 16P to CN2
• 12P to CN3
• 3P to CN6
fig.K-02-e.eps
3. Attaching the PANEL L BOARD
Fasten screws in the 10 locations shown in the figure below.
fig.K-03.eps
A
A
B
The reinforcing plate is
an inside of the ground
The reinforcing plate
is the lower side.