Roland RD-700SX - Restoring Factory Settings

26
Jan. 2005 RD-700SX
4. Attaching the Coated Clips to the Top Panel
Attaching the coated clips as shown in the figure below.
fig.K-04.eps
5. Arranging the Wiring
Peel off the backing from the 20-mm double-sided tape and arrange the cabling.
fig.K-05-1-e.eps
Note: Remove the backing from the 50-mm double-sided tape only where it is to be affixed; do not remove the entire backing.
fig.K-05-2-e.eps
6. Apply the 20-mm double-sided tape (apply above the Banguard).
fig.K-06-e.eps
40122923 DOUBLE FACED ADHESHIVE TAPE NITTO NO.501F W20MM 20M
CN3 (left side)
Bend
Bend by Stand nut place.
Caution:
Prevent the Stud nut being hit.
CN2 (right side)
Caution:
Press the full part of Ban card and put it on the Double-sided tape firmly.
Bend by center
of OUTPUTL,R place.
Put it from an inside point of bend
Put it over the Ban card.