27
Jan. 2005 RD-700SX
7. Affix two layers of double-sided tape (cushioned) to the JACK BOARD surface.
As shown in the figure below, attach the tape to the back surface of CN101 and CN103 (peel the backing off the tape after attachment to the board).
fig.K-07.eps
40122556 DOUBLE FACED ADHESHIVE TAPE #575X W30MM 30M 10P 30CM
8. After attaching the JACK BOARD to the TOP PANEL, connect the cables to the JACK BOARD and arrange.
1. Peel the packing from the double-sided tape on the JACK BOARD back surface
2. Connect the 16P cable to CN103.
3. Connect the 20P cable to CN101.
fig.K-08-e.eps
Bend doesn’t inflate by JACKBOARD edge.
Remaining section put the upper and
inside of the ground.
1
2
Put it on the tape of rear side of JACKBOARD and arrange.
(Do not over from the tape.)
Bend
Insert the reinforcing plate into rear side direction.
Caution:
Press all the Ban card and put on the Double-sided tape firmly.
Double-sided tape as
peel sheet condition
BAN CARD from JACK BOARD CN101
Bend by jump over the place
in which the Ban card was below.
Caution: Prevent the Ban card being hit mutually.
Double-sided tape as
peel sheet condition
To Next Page
Loading...
