Roland RD-700SX - Page 27

28
Jan. 2005 RD-700SX
9. Assembling the PANEL R BOARD
Connect the cables to the following connectors.
• 24P to CN5
• 22P to CN7 <- PANEL L CN1
• 3P to CN6 <- PANEL L CN6
fig.K-09-e.eps
10. Attaching the PANEL R BOARD
Fasten screws in the 12 locations shown in the figure below.
fig.K-10.eps
11. Wrap the LCD cabling in 40-mm acetate tape.
fig.K-11.eps
12. Attaching the LCD to the LCD Holder
* Affix acetate tape to rough portions of the holder.
fig.K-12-e.eps
The reinforcing plate is the lower side
The reinforcing plate is the lower side
Insert the Warring from Panel L.
Put on the Acetate.
Caution: Turn.
The Warring of LCD put under.