Roland RD-700SX - Page 28

29
Jan. 2005 RD-700SX
13. Attaching the LCD Holder to the Top Panel
Fasten screws in the 4 locations shown in the figure below.
fig.K-13.eps
14. Connecting the Wiring to the LCD Holder
Connect the cables to the following connectors.
• 3P to CN5
• CN7
fig.K-14-e.eps
15. Connect the Banguard to the LCD holder and install the LCD holder.
fig.K-15-e.eps
16. Arranging the Cables
Arrange the cables as shown in the figure below.
Remove the backing from the double-sided tape.
L Panel, R Panel Banguard
fig.K-16-1-e.eps
LCD Banguard
fig.K-16-2-e.eps
R Panel Banguard
fig.K-16-3-e.eps
This completes the arrangement of the cables.
Caution:
Remaining the Warring put under the LCD board.
The reinforcing plate
is the lower side
Caution:
Press all the Ban card and put on the Double-sided tape firmly.
To fit the edge of the Double-sided tape and bend
Caution: Prevent the Stud nut being hit.
Dent and arrange.
To fit the right edge in
which the Ban card was
below to bent 90 °.
(Both sides are not reversed.)
To fit the edge of the Double-sided tape and bend
Caution: Prevent the Ban card being hit mutually.
Turn upper side
To fit the edge of the Double-sided tape and bend