Roland SH-101 - CPU Program Flow and Modes; Test Mode Operation; Initial Set Procedure; Range Data Handling

4
Using the SH-101 Model Expansion
Installing the SH-101 Model Expansion
Saving Files To a USB Flash Drive
* When using a USB ash drive for the rst time, you must format it
on the JUNO-X.
Ø
“Formatting a USB Flash Drive” (Startup Guide)
1. Connect the USB ash drive to your computer.
2. Save the le (EXM004_SH101.exz) to the root
directory of the USB ash drive.
3. Disconnect the USB ash drive from your computer.
Installing on the JUNO-X
1. Insert the USB ash drive you prepared in “Saving
Files To a USB Flash Drive” into the JUNO-X.
2. Turn the power of the JUNO-X on while holding
down the [ENTER] (INIT) button.
The EXPANSION top screen appears.
Memory used
EMPTY:
A new le can be installed.
FULL:
A new le cannot be installed.
You must free up some memory
for installation.
Ø
“Uninstalling a Model Expansion” (p. 4)
List of installed Model Expansions
Uninstall
([
Í
] button)
Install
([Ë] button)
3. Press the [
Ë
] button to go to the installation screen.
4. Use the [
Ç
SELECT
É
] knob to select “EXM004_
SH101”, and press the [ENTER] (INIT) button or the
[
Ë
] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
MEMO
The user license registration screen appears if you’re installing for
the rst time.
To continue installing, use the [
Ë
] button to select “OK”, and then
press the [ENTER] (INIT) button.
5. To execute, use the [- VALUE +] knob to select “OK”,
and then press the [ENTER] (INIT) button.
6. Turn the power o, then on again.
This allows you to use the SH-101 Model Expansion.
Error Messages
Indication Action
Expansion Memory Full!
There is not enough memory available for installation.
Follow the steps in “Uninstalling a Model Expansion” to
free up the memory.
Incorrect License! Please
Remove License
The SH-101 Model Expansion is currently linked to a
dierent user license.
Follow the steps in “Initializing Your User License”
(p. 5) to initialize the user license.
Uninstalling a Model Expansion
If there is not enough free memory, you can uninstall Model
Expansions that are already installed, and then install the SH-101
Model Expansion.
1. Hold down the [ENTER] (INIT) button and turn the
JUNO-X on.
The EXPANSION top screen appears.
2. Use the [
Ç
SELECT
É
] knob to select the le to
uninstall, and then press the [
Í
] button to go to the
uninstallation screen.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
3. To execute, use the [- VALUE +] knob to select “OK”,
and then press the [ENTER] (INIT) button.
MEMO
The uninstall process works the same even if you’ve installed the
Model Expansion with Roland Cloud Connect (WC-1).