Roland SH-5 - Page 48

1976-10-30 SH-5
HPF Width Reset OSC Vertical for larger range and note reading produced by F1. Strike F2; adjust VR-502 for
half(-6dB) reading.
Key F1
0 4Vpp
Key F2
Repeat the above step until
F2=1/2F1.
Check that F3=112 F2; F4= 1 /2 F3.
0.4Vpp
Key F3
0.2Vpp
FPF Freq.
(Step-2)
OSCILLOSCOPE
\£J CIRCUIT BOARD
T ASSEMBLY
HPF (OP21)
FREQ
(VR501)
t
Press F2; adjust VR-50] so that
base line is as stright as possible.
-47-
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html