3-51
4
To protect the Heads, select [I/S MENU] > [I/S
CONTROL] > [CAP] > [OPEN]. And press the [ENTER]
key to move down the Capping Unit.
[ ]
SERVICE MENU
I/S MENU
I/S MENU
I/S CONTROL
I/S CONTROL
CAP
[ ]
[ ]
CAP
OPEN
[ ]
2
1
3
3-9 CARRIAGE BELT REPLACEMENT
Main Power SW
< Rear view >
Remove the following covers.
Right I/S Cover
Top Cover
Right Top Cover
Front Rail Cover
Front Cover
Panel Cover
Left I/S Cover (XJ-740 only)
Front Cover
Right I/S Cover
Top Cover
Front Rail Cover
Right Top Cover
Panel Cover
After turning on the Main Power SW, turn on the Sub
Power SW while pressing the Left, Right and Down keys
to enter the Service Mode.
Flexible Cable is connected to the Panel
Board. Do not disconnect the Flexible Cable.
Left I/S Cover
MENU
SERVICE MENU
+
MENU
Turn off the Sub Power SW, and then turn off the Main
Power SW.
To Next Page
Loading...
Need help?
General