If you press [PATCH CHAIN] to select another Chain before pressing [ALL/ENTER], the Patch
Chain settings you just made will be lost.
6
If you wish, you may make settings for another Patch Chain.
7
When you finish making Patch Chain settings, press [EDIT] to return
to the Play mode.
Using a Patch Chain to Select Patches
Here’s how to step through the Patches in a Patch Chain.
1
In the Play mode, press [PATCH CHAIN] to select the Patch Chain
you wish to use (A, b, C, d, e, F, G,H).
fig.36
A Patch Chain which does not contain any data will not be displayed in the Play mode.
2
Each time you press PATCH/VALUE [-] or [+]the next Patch in the
Chain will be selected.
After the last Patch in the Chain, you will return to the first Patch.
A footswitch connected to the FOOT SW jack can also be used to select Patches.
3
Press [PATCH CHAIN] several times to return to the Play mode.
Erasing a Patch Chain
Here’s how to erase the current Patch Chain settings.
1
Press [EDIT] to enter the Edit mode.
2
Use [PATCH CHAIN] to select a Patch Chain, and press [ALL/ENTER]
to erase it. The following display will appear.
fig.37
3
Press [EDIT] once again to return to the Play mode.
After all chains are cleared, the Patch Chain cannot be used, even if you press [PATCH CHAIN] in
the Play mode.
To Next Page
