3. Assemble the opposing stand leg by following the same procedure from step 1 to step 2.
4. Position the left and right stand legs parallel to each other and separated by approximately 1,550 mm
(61 in.) for the 54-inch model or approximately 930 mm (36.6 in.) for the 30-inch model.
Position the legs so that the L-shaped brackets face the inside and the side of the tabletop plate
with the hole (A) faces down for each leg.
5. Place the stand stay on the stand legs.
Position the stand stay with attachment holes (A) toward the casters.
6. Use eight bolts to secure the stand stay.
(1) Temporarily tighten the bolts in the four locations indicated with A followed by the four locations
indicated with B.
(2) Fully tighten the bolts in the four locations indicated with A.
1. Assembly and Ink Filling
Installation 11
To Next Page
Loading...
