Roland TrueVIS SG3-540 - Step 5: Installing the Drain Bottle

Step 5: Installing the Drain Bottle
Procedure
1. Remove the drain pad.
Discharged fluid used in the inspection when the printer was shipped may remain. Exercise cau-
tion.
2. Install the drain funnel.
Screw the drain funnel all the way into the hole where the drain pad was attached.
Use caution to turn the bottle without applying excessive force.
IMPORTANT
3. Insert the drain bottle stand into the grooves , and then slide it in the direction indicated in the figure
.
1. Assembly and Ink Filling
30 Installation