(2) Align the surface of the printer unit (A) and the center position of the rhombus mark (B) on the
stand as seen from the inside to the outside. (Align the front and rear sides.)
4. Place the printer unit on the stand.
Be sure to have workers support the printer unit right up to step 6. This unit may fall over if it is released
before being fixed in place with bolts in step 6.
IMPORTANT
5. Make sure there are no gaps between the tabletop plates of the left and right stands and the printer unit.
The printer's center of gravity is at its back, so there may be a gap at the front of the printer.
MEMO
1. Assembly and Ink Filling
14 Installation
To Next Page
Loading...
