Hold the pieces together so there is no gap between the left arm and stand when tightening the bolts.
IMPORTANT
4. Make sure the protrusions on the stand leg (A) are in the center of the holes on the arm (B).
Move the arm to the left and right until these protrusions are centered.
5. Temporarily tighten the bolts at the bottom of the left arm.
6. Use a hexagonal wrench to fully tighten the upper bolts followed by the lower bolts .
7. In the same manner, attach the right arm to the right side as seen from the rear of the printer.
1. Assembly and Ink Filling
Installation 17
To Next Page
Loading...
