(3) Tap [OK].
(4) Tap [Save].
If you are using the computer and the machine on a one-to-one basis, this completes the set-
tings to make on the printer.
Go back to the original screen. Then, proceed to Setting the Software RIP(P. 55).
If you need to set the gateway address, proceed to the following procedure.
3. Set the gateway address.
(1) Tap
next to [Default Gateway].
(2) Set the default gateway (192.168.0.XXX).
For the value to enter for your default gateway, contact your network administrator. Here,
[192.168.0.1] is entered by way of example.
(3) Tap [OK].
(4) Tap [Save].
4.
Tap to go back to the original screen.
3. Network Settings
Installation 51
To Next Page
Loading...
