2. Install the required software from Roland DG Connect Hub.
Use Roland DG Connect Hub to install the related software. After software is installed, you can perform
operations such as starting and updating the software from Roland DG Connect Hub.
Procedure
1. From the Windows Start menu, click [Roland DG Corporation]>[Roland DG Connect Hub].
2. Refer to the Initial_Setting_Guide in the folder extracted from [RolandDG_Connect_Setup.zip] to perform
the following operations.
(1) Create a Roland DG Connect ID.
If you already have an ID, proceed to the next step.
(2) Configure the Connect Hub settings.
3. On the main screen, click the machine to use.
The software that can be used with the selected machine is displayed in the window on the right
side of the screen.
4. Install all the software displayed on the right side of the screen.
When the installation is finished, click the Close button ("X") in the upper-right corner of the main screen to
minimize Roland DG Connect Hub to the notification area. Although Roland DG Connect Hub is no longer dis-
played, it is still running. The icon of Roland DG Connect Hub is displayed at all times in the notification area
while this software is running.
MEMO
4. Downloading and Installing Software
54 Installation
To Next Page
Loading...
