Roland V-Drums TD-20 - Chapter 9. Using a CompactFlash Memory Card [CARD]; Saving Data to a Memory Card

70
Chapter 9. Using a CompactFlash Memory Card [CARD]
You can use an optional CompactFlash memory card to save
TD-20 settings and sequencer data.
CARD MENU screen
fig.09-CardMenu_70
Cards supported by TD-20 are 3.3 V CompactFlash
cards with the capacity of 16 to 512 MB.
You can check the amount of memory card available by
pressing [TOOLS] - [F2 (INFO)] - [F2 (CARD)] (p. 84).
Save/Load and Copy Functions of the TD-
20
fig.CardImage
All data (drum kits, percussion sets, patterns, and setup) will
be saved up to 8 sets.
1. Insert a CompactFlash card into the
CompactFlash card slot on the TD-20’s front
panel.
2. PRESS [CARD].
[CARD] AND the CompactFlash indicator light, and the
“CARD MENU” screen appears.
* If you insert a card being used for the first time by the TD-20,
display shows “Unformatted!” Refer to p. 72 and initialize it.
3. Press [F1 (SAVE)].
The “CARD SAVE” screen appears.
fig.09-CardSave1_70
4. Use [+/-] or [VALUE] to select a backup area to
which you want to save the data.
* You can select an empty backup area with the lowest number
by pressing [F4 (NEW)].
5. Press [F5 (SAVE)].
The confirmation screen appears.
fig.09-CardSave2_70
* To cancel, press [F1 (CANCEL)].
6. If you want to change the name of the backup
area, press [F4 (NAME)].
7. Press [F5 (EXECUTE)] to save the data.
930 (Modified)
* Never remove a CompactFlash card while the
CompactFlash indicator on the TD-20’s top panel is lit.
Doing so may corrupt the unit’s data or the data on the
CompactFlash card.
931
* Carefully insert the CompactFlash card all the way in—
until it is firmly in place.
Backup (1–8)
Pattern (1–100)
KIT
PERC
SETUP
TRIG
CHAIN
PATTERN
SETUP
TD-20
CompactFlash
[COPY]
[CARD]
[SAVE][LOAD]
[LOAD]
[SAVE]
[PATTERN] - [EDIT] - [CARD]
PERC
KIT
INST
TRIG
CHAIN
PATTERN
PATTERN
INST
Saving Data to a Memory
Card [F1 (SAVE)]
TD-20_Ref_e.book 70 ページ ２００４年３月５日 金曜日 午後７時３分