54
Chapter 6. Sequencer (Playback)
PATTERN PART screen (Only for User Pattern)
fig.06-Part_70
You can mute specific parts in user patterns.
1.
Press [PATTERN] - [F2 (PART)].
The “PATTERN PART” screen appears.
2.
Press [F1 (MUTE)].
The “PART MUTE” screen appears.
fig.06-Mute1_70
3.
Press [F1]–[F5] to turn each part muted or
played.
[F1]: Melody Part
[F2]: Bass Part
[F3]: Backing 1 Part + Backing 2 Part
[F4]: Percussion Part
[F5]: Drum Kit Part
4.
Press [PATTERN] to return to the “PATTERN”
screen.
* You can check the part mute status in the “PATTERN” screen.
fig.06-Mute2_70
Here you can select the instrument used for the backing parts
(other parts than drum kit part and percussion part), etc.
1.
Press [PATTERN] - [F2 (PART)].
The “PATTERN PART” screen appears.
2.
Press [F2 (BACKING)].
The “MELODY (BASS, BACKING1, BACKING2)PART”
screen appears.
fig.06-Backing_70
3.
Press [F1]–[F4] to select the part you wish to
set.
[F1]: Melody Part
[F2]: Bass Part
[F3]: Backing 1 Part
[F4]: Backing 2 Part
4.
Press [CURSOR (up/down)] to select the
parameter.
5.
Use [+/-] or [VALUE] to make settings.
Part Settings [F2 (PART)]
Muting a Specific Part [F1 (MUTE)]
MUTE PLAY
Make Settings for the Backing Part
[F2 (BACKING)]
Parameter Value Description
Inst Refer to
Backing
Instrument List
(p. 98)
Part Instrument
Key Shift -24–0– +24 Shifts the overall
pitch (in semi-
tone steps).
Bend Range 0– +24 Amount of
change in pitch
with pitch bend
at the maximum
level (in semitone
steps).
TD-20_Ref_e.book 54 ページ ２００４年３月５日 金曜日 午後７時３分
To Next Page
Loading...
