81
Chapter 10. Settings for the Entire TD-20 [SETUP]
Chapter 10
[SETUP]
You can specify which is used for the master effect (p. 43),
individual settings for each drum kit or common settings to all
kits.
1.
Press [SETUP].
[SETUP] lights.
2.
Press [F4 (OPTION)] - [F2 (COMP/EQ)].
The “MASTER COMP/EQ MODE” screen appears.
fig.10-Master_70
3.
Use [+/-] or [VALUE] to make settings.
INDIVIDUAL:
Master effect for each kit, individually.
GLOBAL:
Master effect common to other drum kits is
used.
When this is set to “GLOBAL,” “GLOBAL” appears on the
icon at the left part of the master effect setting screen.
fig.10-Master2_70
The display contrast is strongly influenced by the location of
the TD-20 and the lighting of the room it’s in. Adjust this
parameter when needed.
1.
Press [SETUP].
[SETUP] lights.
2.
Press [F4 (OPTION)] - [F5 (LCD)].
The “LCD CONTRAST” screen appears.
fig.10-Display_70
3.
Use [+/-] or [VALUE] to adjust.
* You can also adjust it by holding [KIT] and turning [VALUE].
This restores the TD-20 to the original factory settings
(
Factory Reset
).
All data and settings stored in the TD-20 are lost in
carrying out this operation. So if necessary, save your
data to a memory card or an external MIDI device before
executing the factory reset (p. 70, p. 77).
1.
Press [SETUP] - [F5 (F RESET)].
[SETUP] lights, and the “FACTORY RESET” screen
appears.
fig.10-Factory1_70
2.
Press [F5 (RESET)].
The confirmation screen appears.
fig.10-Factory2_70
* To cancel, press [F1 (CANCEL)].
3.
Press [F5 (EXECUTE)] to execute Factory
Reset.
When Factory Reset is finished, the “DRUM KIT” screen
appears.
When Factory Reset is carried out, the [GROUP FADERS]
settings values are set to the maximum volume,
regardless of the slider positions.
Master Effect Mode [F2 (COMP/EQ)]
Adjusting the Display Contrast
[F5 (LCD)]
Restoring the Factory
Settings [F5 (F RESET)]
TD-20_Ref_e.book 81 ページ ２００４年３月５日 金曜日 午後７時３分
To Next Page
Loading...
