Roland V-Drums TD-20 - Using Pads as Switches [F2 (PAD SW)]; Other Settings [F4 (OPTION)]; Preview Button Settings [F1 (PREVIEW)]

80
Chapter 10. Settings for the Entire TD-20 [SETUP]
Pads connected to TRIGGER INPUT 15 (AUX4) and/or 14
(AUX3) can be set to switch drum kits and play back patterns.
1. Connect the pad(s) to the TRIGGER INPUT 15
(AUX 4) and/or 14 (AUX3).
2. Press [SETUP].
[SETUP] lights.
3. Press [F3 (CONTROL)] - [F2 (PAD SW)].
The “PAD SWITCH” screen appears.
fig.10-PadSw_70
4. Use [+/-] or [VALUE] to select the function.
5. When setting to “USER,” press [CURSOR] to
move the cursor to “AUX3” and “AUX4.”
6. Use [+/-] or [VALUE] to select the functions for
the heads and rims of AUX3 and AUX4.
• If you don’t want sound from the pad used as a pad
switch, press [MIXER] - [F1 (VOLUME)], and set the
volume level for AUX4 and/or AUX3 to “0” (p. 37). Or
press [INST] and select “561 Off” for AUX4 and/or AUX3
(p. 31).
• When using pad switches to switch kits in a Drum Kit
Chain (p. 82), FUNCTION should be set to “KIT SELECT
1” or “KIT SELECT 2,” and you need to press the
[CHAIN], so its indicator is lit. (The Drum Kit Chain
settings need to be made beforehand.)
Here, the [PREVIEW] velocity can be set.
1. Press [SETUP].
[SETUP] lights.
2. Press [F4 (OPTION)] - [F1 (PREVIEW)].
The “PREVIEW” screen appears.
fig.10-Preview_70
3. Press [CURSOR (up/down)] to select the
parameter.
4. Use [+/-] or [VALUE] to make settings.
Using Pads as Switches
[F2 (PAD SW)]
Function AUX3 AUX4
Head Rim Head Rim
OFF OFF OFF
KIT SELECT1 OFF KIT#
INC
KIT#
DEC
KIT SELECT2 KIT# DEC KIT# INC
CHAIN SELECT1 OFF CHAIN
# INC
CHAIN
# DEC
CHAIN SELECT2 CHAIN# DEC CHAIN# INC
PATTERN
SELECT1
OFF PTN#
INC
PTN#
DEC
PATTERN
SELECT2
PTN# DEC PTN# INC
USER Select from the table below.
OFF Turns off Pad Switch.
KIT# INC Calls up the next kit.
KIT# DEC Calls up the previous kit.
CHAIN# INC Calls up the next drum kit chain.
CHAIN# DEC Calls up the previous drum kit chain.
PTN# INC Calls up the next pattern.
PTN# DEC Calls up the previous pattern.
XSTICK SW Switches to use/not use cross stick.
Other Settings [F4 (OPTION)]
Preview Button Settings
[F1 (PREVIEW)]
parameter
Value Description
Dynamics
OFF,
ON
OFF: No velocity. Level is fixed.
ON: Button responds to velocity.
Velocity 1–127 Velocity when Dynamics is set to
“OFF.”
TD-20_Ref_e.book 80 ページ ２００４年３月５日 金曜日 午後７時３分