79
Chapter 10. Settings for the Entire TD-20 [SETUP]
Chapter 10
[SETUP]
Two foot switches (BOSS FS-5U, optional) can be used with an
optional cable (PCS-31) to switch drum kits and play back
patterns.
fig.FootSw.e
o: Functions –: Does not function
1.
Connect the foot switches to the FOOT SW jack.
2.
Press [SETUP].
[SETUP] lights.
3.
Press [F3 (CONTROL)] - [F1 (FOOT SW)].
The “FOOT SWITCH” screen appears.
fig.10-FootSw_70
4.
Use [+/-] or [VALUE] to select the function for
foot switches.
5.
When setting to “USER,” press [CURSOR] to
move the cursor to “SW1” or “SW2.”
6.
Use [+/-] or [VALUE] to select the functions for
SW1 and SW2.
When using foot switches to switch kits in a Drum Kit
Chain (p. 82), FUNCTION should be set to “KIT
SELECT,” and you need to press the [CHAIN], so its
indicator is lit. (The Drum Kit Chain settings need to be
made beforehand.)
Setting the Switches
[F3 (CONTROL)]
Using Foot Switches [F1 (FOOT SW)]
Foot Switch
SW1 SW2
FS-5U x 2 (PCS-31)
o (red plug) o (white plug)
DP-2 – o
PCS-31
(sold separately)
FS-5U
Function SW1 SW2
KIT SELECT KIT# DEC KIT# INC
CHAIN SELECT CHAIN# DEC CHAIN# INC
PATTERN SELECT PTN# DEC PTN# INC
PATTERN PLAY PTN# INC STOP/PLAY
USER Select from the table below.
KIT# INC Calls up the next kit.
KIT# DEC Calls up the previous kit.
CHAIN# INC Calls up the next drum kit chain.
CHAIN# DEC Calls up the previous drum kit chain.
PTN# INC Calls up the next pattern.
PTN# DEC Calls up the previous pattern.
PTN PLAY Plays back the pattern.
PTN STOP Stops the pattern.
STOP/PLAY Plays back/stops the pattern.
XSTICK SW Switches to use/not use cross stick.
TD-20_Ref_e.book 79 ページ ２００４年３月５日 金曜日 午後７時３分
To Next Page
Loading...
