EasyManua.ls Logo

Roland VS-2480 - CD-R;RW Operations; Creating an Audio CD

Roland VS-2480
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27—Mastering and CD-R/RW Operations
Roland VS-2480 Owner’s Manual www.rolandus.com 349
CD-R/RW Operations
All CD-R/RW operations described in the following sections start on the CD-RW
MASTERING MENU screen. To get there:
1. Press CD-RW—the CD-RW MASTERING MENU screen appears.
Creating an Audio CD
Track at Once or Disk at Once?
The VS-2480 allows you to select the way you want to write an audio CD:
adding tracks to a CD one at a time
—This can be a great way to compile a CD of work
mixes to listen to. As you create each new mix, burn it onto your work CD. This
method of creating a CD is called “Track at Once” or “TAO” for short. You can create
Track at Once CDs only with CD-R disks.
writing all of the tracks in a single CD-burning process
—When you’ve created
mastering tracks that contain all of a CD’s selections positioned as you want them,
you can burn the entire “Disk at Once, as this method’s called, or “DAO” for short.
Finalizing
Before a CD can be played on an ordinary CD player, certain important information
must be written onto the CD, including track numbers and a Table of Contents, or
“TOC. This last step in the CD-creation process is called “finalizing. Until then, the
CD can be played only on your VS-2480 or another Roland V-Studio with a connected
Roland-approved CD-R/RW drive—see “The CD Player Feature” on Page 353.
Once a CD-R’s been finalized, no more audio can be added to it—you can erase a CD-
RW and start over. You can finalize a CD during the CD creation process. To finalize a
CD without adding audio, use the procedure on Page 349, setting Finalize to OnlyFin.
CD operations on the VS-2480 require a connected Roland-approved CD-R/RW drive.
If you’re creating CDs, you’ll also need blank CD-R or CD-RW discs.
To learn how to connect a Roland-approved CD-R/RW drive to your VS-2480, see
Page 381.
One of the most important CD-R/RW operations is the PROJECT menu’s BACKUP
operation, described in Chapter 7, on Page 105.
If you encounter error messages while using your CD-R/RW drive, see Page 353 or the
VS-2480 Appendices
for explanations of the VS-2480’s error messages.
If you plan to mass-duplicate your CD when it’s done, check with the duplication
service you’re going to use—some duplicators accept only DAO-created CDs.
VS2480OMUS.book 349 ページ 2006年2月7日 火曜日 午後4時16分

Table of Contents

Other manuals for Roland VS-2480

Related product manuals