2—Getting Around
Roland VS-2480 Owner’s Manual www.rolandus.com 47
4—SMPTE IN Jack
When synchronizing the VS-2480 as a slave to an external SMPTE-generating device,
connect the external device’s SMPTE output to the VS-2480’s SMPTE IN jack.
Synchronization is discussed in Chapter 24, starting on Page 307.
5—PS/2 KEYBOARD and MOUSE Jacks
Connect a PS/2 ASCII keyboard (purchased separately) and mouse (shipped with the
VS-2480) to the PS/2 KEYBOARD and MOUSE jacks, respectively. See Page 62.
6—MIDI OUT/THRU Jack
By default, this jack functions as a MIDI output jack—connect it to the MIDI input of
any device to which you wish to send MIDI data from the VS-2480 (see Chapter 24,
Page 299). You can also set the MIDI OUT/THRU jack to function as a THRU jack that
passes along any MIDI data the VS-2480 receives from an external device (Page 300).
7—MIDI IN Jack
Connect the MIDI output of an external device to the MIDI IN jack when you want the
VS-2480 to receive and respond to MIDI data transmitted from an external device. See
Chapter 24, starting on Page 299.
8—FOOT SWITCH Jack
You can control a variety of VS-2480 functions using an optional foot switch—such as a
Roland DP-2 or BOSS FS-5U—connected to this jack. See Page 362.
Slave
PS/2, ASCII
WORD CLOCK IN
VGA OUT
SCSI
RLRLRL
FOOT
SWITCH
MONITOR AUX AAUX B
34
R L
MASTER
125678PHONES 1PHONES 2
ANALOG MULTI OUTPUT
KEYBOARD
SMPTE
IN
MOUSE
MIDI
INOUT /THRU
PS/2
OUT IN
OUT IN
DIGITAL
OPTICAL
2
COAXIAL
THIS DEVICE COMPLIES WITH PART 15 OF
TO THE FOLLOWING TWO CONDITIONS:
THE FCC RULES. OPERATION IS SUBJECT
(
1
)
THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND
(
2
)
THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
/
DIGITAL 8ch I / ODIGITAL 8ch I / O
1
+
4dBu BALANCED / -2dBu UNBALANCED
(
TIP
)
(
RING
)(
SLEEVE
)
HOT
COLD
GND
45 6789 10
1211 13 14 15
16
VS2480OMUS.book 47 ページ ２００６年２月７日 火曜日 午後４時１６分
To Next Page
Loading...
