Roland XP-10 - Page 13

Chapter 1. Before you play
Connections
In order to play the XP-10, you will need to connect an amp/speaker system. Before
making connections, turn off the power of the XP-10 and the amp and mixer. Also be
sure to set the volumes of the amp and mixer to the minimum position. This will prevent
the speakers from being damaged by noise that may occur when connections are made
or when power is turned on.
Refer to the following diagram and connect the XP-10 to the other equipment.
MIDE output
THRU out RR LIMONO}- PHONES: gH = POWER
X00nA ROOF
d- oes
pails
.
Ee)
O
©
©
©
[2]
COMPLUES WITH PART {5 OF THE FEC AULES OPERATION 1S SUBUECT TO THE FOLL MONS. 1) THIS DEVICE WAY NOT CAUSE HARLIFUL USE ACL AND AC)
SITEAPENENCE AA) 1) ES DEVICE MUST ACCEPT Ait TPHEERENCE RECEWED BrCl Und RITIFENEMCE THAT WAY CALE WODESRED OFAN ‘ADAPTOR ONLY
AC adaptor
External MIDI device
v
Stereo headphones
ovewer
Expression pedal (EV-5; sold Reagseen
separately) or pedal switch(DP-2/6,
FS-5U; sold separately)
Stereo set, etc. keyboard amp, etc.
Speaker with built-in amp,
Computer
About the AC adaptor jack
Be sure to use only the included AC adaptor. Using any other AC adaptor may result in
accidents or malfunctions.
About the output jacks
In order to take full advantage of the XP-10’s capabilities, we recommend that you listen
to it in stereo. If you are using a mono system, connect the L(MONO) jack.
* Expression pedals and pedal switches are sold separately.
* Use headphones that have a rating of 8-150 ohms.
* Be sure to use expression pedals and pedal switches manufactured by Roland or Boss.
Pedals of other manufacturers may not operate correctly with the XP-10.
13