Roland XP-10 - Page 12

Panel Descriptions
AS gn AI SR I I Te TLD I ET I a ST
Side
panel
25.
AC
adaptor
jack
Connect
the
included
AC
adaptor
here.
26. Power switch
This switch turns the power on/off.
18. Pitch Bender/Modulation lever
Use this to raise or lower the pitch of the sound, or
add vibrato. This lever can also control many other
functions, for example allowing you to modify the
tone color or the arpeggio pattern as you play.
Rear panel
19 20 21 22 23 24 25 26
19. Computer switch
Set this switch depending on the type of computer
connected to the Computer connector, or the software
you are using. Turn the power off before changing the
setting of this switch. If you wish to use the MIDI con-
nectors, set this switch to MIDI (p.55).
20. Computer connector
A computer can be connected to this connector using
a computer cable. The type of cable required will
depend on your computer (p.54, p.66). When the
Computer switch located at the left is set to MIDI, the
Computer connector cannot be used.
21. MIDI connectors
MIDI devices can be connected to these connectors
using MIDI cables.
22. Pedal jack
A separately sold expression pedal (EV-5, etc.) or
pedal switch (DP-2/6, FS-5U, etc.) can be connected
here. A function can be assigned to the connected
pedal, for example letting you use the pedal to sustain
the sound or modify the tone color.
23. Output jacks
Connect an amp or mixer to these jacks.
24. Headphone jack
A pair of headphones can be connected here. Sound
will be output from the output jacks even if head-
phones are plugged in.
12