Part No. 4801-5329 Rev 3-09 SW 100 Sidewall Curtain System Page 15
Figure 15 – Manually Close Curtain
Reference to Items in Figure 12 – Adjust Limit Switches
Item Description Item Description
1 Switch HII 11 HI Setting Ring Screw
2 Switch HI 12 Setting Ring
3 Not Used 13 HI Setting Ring Screw
4 Terminal Rail 14 HII Setting Ring
5 Not Used 15 HII Setting Ring Screw
6 Not Used 16 HI Setting Ring
7 Not Used 17 HII Setting Ring Screw
8 Setting Ring 18 SII Setting Ring
9 SI Setting Ring Screw 19 SII Setting Ring
10 HI Setting Ring 20 Not Used
To set the Limit Switches, locate the Lock Motor Control Box. See
Figure 13. NOTE: Items noted in brackets [ ] in this section can be
found in Figure 12.
1. Unscrew the limit Switch Cover and locate the
Allen Wrench and the hex shaft packaged in the
Vinyl Storage Seal. See Figure 14.
2. Remove the Vinyl Storage Seal and locate the six
Hex Adjusting Screws on the Ring Screws. See
Figure 15.
3. Run the curtains to the bottom position by using a
Crank or Drill [Item 14 Figure 11] or by manually
turning the one of the three Left Adjusting Screws
with the Allen Wrench from the Vinyl Seal as
illustrated in Figure 15. NOTE: If turning the drive
with drill and adaptor, run to end position carefully
(very slowly). Maximum drive speed is 1400 rpm.
NOTE: Electrical power must be applied and Limit
Switches must be properly wired for curtains to
operate by moving the Setting Rings.
Limit Switch
Cover
removed
Allen wrench
for adjusting
Limit Switches
Hex shaft for
manually
rotating motor
inyl
Storage
Seal
Figure 14 – Remove Limit Switch Cover
Lock Moto
Figure 13 – Lock Motor
Limit Switch
Cove
Curtain Moves Down
To Next Page
Loading...
General