Romac Transmate TapMate - Cutter and Pilot Identification

TAPMATE
™
XL 424 OPERATING MANUAL
6
CUTTER AND PILOT IDENTIFICATION
1. Select the proper Cutter and Pilot for the pipe you'll be tapping (see g. 4 & 5).
70;/6+$)7126(
7$36
70;/6+$)7126(
7$36

7<3,&$/&$5%,'(&877(5'(6,*1

7<3,&$/&$5%,'(&877(5'(6,*1
&XWWHUDQG3LORWVVKRZQEHORZDUHIRUXVHRQ'XFWLOH,URQ&DVW,URQDQG$VEHVWRV&HPHQWSLSH
706+$)7126(
7$36
TM-XL, PVC PILOT
(14" - 16" TAPS)
TM-XL, PVC PILOT
(18" - 24" TAPS)
4" - 12"
TYPICAL PVC CUTTER DESIGN
TM, SHAFT NOSE
(4" - 12" TAPS)
g. 4
g. 5
Cutter and Pilots shown below are for use on Ductile Iron, Cast
Iron and Asbestos/Cement pipe.
Cutter and Pilots shown here are for use on PVC pipe.
NOTE: USE CARBIDE CUTTER PER FIG. 4 FOR 14” THRU 24” CUTS