© 2017 Ropam Elektronik
- do not confirm by the SMS the inclusion of the outputs: option selected - if the control of the outputs
is made by SMS commands then the module does not send confirmation of the activation / change of
the output status in the form of SMS.
OTHER OPTIONS
- Pressing (#DTMF) aborts the voice call: Pressing # on the telephone keypad during an ongoing
voice call with the module terminates the voice prompt (played from VSR-1, VSR-2 or audio message
from BasicGSM 2 memory).
Tab: Temperature.
BasicGSM 2 allows you to measure temperature with the digital temperature sensor TSR-xx.
The temperature is measured every 30 seconds. The accuracy of the measurement is 0.5 st.
Based on the temperature measurement, LogicProcessor functions can be used to send a notification
of changes in temperature parameters and failure of the temperature sensor.
VIEW OF WINDOWS TEMPERATURE SETTINGS
- Name: temperature sensor name (required for display in SMS STAN, RopamBasic, RopamDroid).
- Alarm when: the module sends a notification in the form as below (required selection of the required
forms of notification of exceeding the set temperature threshold).
To Next Page
Loading...