EN
31
3. Bike assembly
This chapter aims at helping you remove your bike from the ROSE bike box and re-assemble it.
Depending on the bike model, different components may have been removed or repositioned for shipping. In addition, you
have to fit the pedals and check whether your bike is in a roadworthy condition.
DANGER
Improperly installed components can cause serious crashes!
Any improperly installed components could loosen during the ride!
• Always follow the installation instructions included in this manual.
• If in doubt, please consult the ROSE Service Team or a qualified bicycle mechanic.
Scan this QR code with your smartphone for further
information and videos on how to assemble your
bike.
3.1 Required tools
Depending on bike model and equipment, you will need the following tools for assembly:
• 4 mm, 5 mm, 6 mm, 8 mm hex wrench
• T25 star wrench
• Torque wrench with a 4 mm, 5 mm, 6 mm and 8 mm hex drive
• 15 mm open-ended spanner
To Next Page
Loading...