What to do if Rosemount 3051S Transmitter is not joined to the network after power up?
If the Rosemount Transmitter doesn't join the network after powering up, verify that the network ID and join key are configured correctly. Also, confirm that active advertising is enabled on the Gateway. The network ID and join key in the device must match those of the Gateway.
General| Type | Pressure Transmitter |
|---|---|
| Temperature Range | -40 to 185 °F (-40 to 85 °C) |
| Accuracy | Up to ±0.025% of span |
| Output | 4-20 mA HART, FOUNDATION Fieldbus |
| Process Connection | 1/2 NPT |
| Material | Alloy C-276 |
| Power Supply | 10.5 to 42 V DC (HART) |
| Stability | ±0.1% of URL per 5 years |
| Enclosure Rating | NEMA 4X, IP66 |
| Electrical Connection | 1/2-14 NPT, M20 x 1.5 |
| Response Time | 100 ms |
Describes the correct sequence for powering up wireless devices with the gateway.
Guidance on optimal placement of the antenna for clear communication.
Details on connecting a Field Communicator for transmitter interface.
Instructions for mounting the transmitter in liquid flow applications.
Instructions for mounting the transmitter in gas flow applications.
Instructions for mounting the transmitter in steam flow applications.
Guidelines for proper bolting to ensure a tight seal during installation.
Proper installation and handling of O-rings for flange adapters to prevent leaks.
Optional installation of a high gain, remote antenna for improved wireless performance.
Procedure for zero trimming to compensate for mounting position and line pressure effects.
Instructions for properly closing and sealing the transmitter housing.
How to check device status and output values on the local LCD display.
Verifying operation using a Field Communicator.
Checking device status via the Gateway's web interface.
Using the AMS Wireless Configurator to verify device status.
Guidance on resolving issues if the device does not join the network.
Details on conformity with European Union directives.
Information regarding wireless RF spectrum regulations and certification.
Compliance statements for FCC and Industry Canada regulations.
Standard certification for ordinary location requirements.
Notes on NEC and CEC requirements for installation.
Specific safety certifications and standards for the USA.
Specific safety certifications and standards for Canada.
Specific safety certifications and standards for Europe (ATEX).
Specific safety certifications and standards for international regions.
Specific safety certifications and standards for Brazil (INMETRO).
Specific safety certifications and standards for China.
Specific safety certifications and standards for Japan (TIIS).
Specific safety certifications for EAC region (Belarus, Kazakhstan, Russia).
Specific safety certifications for the Republic of Korea.
Information on combined certifications.
To Next Page