Safety
- 24 -
Warning notes
Danger of injury due to burns!
A short circuit releases powerful currents that can considerably heat up and
even melt metals.
Use only jump start cables in line with ISO 6722 and NATO connector.
In case of jump start cables with crocodile clips, ensure correct polarity.
Never short-circuit battery poles or the jump start cable.
Avoid unintended connecting of the positive pole and electrically
conductive vehicle parts by tools, watches, jewelry etc.
Do not connect the jump-start cable to fuel, hydraulics or brake lines.
Danger of crushing or material damage due to moving parts!
Moving components that have not latched into position, or are not at their
limit positions, can cause injury to persons or material damage.
Only hold compartment doors and steps at suitable points.
Before opening swing-out shelves and swivel reels, fully open the
roller shutters in question.
Observe spring and inertia effects when opening and closing
compartment doors and the rear step.
Pay attention while closing the seat box cover.
Injury to persons and material damage due to unexpected releasing of
connecting couplings!
Before start of operation (pressure), check all connecting couplings (A,
B, C, D, HP) with a coupling wrench to ensure tight seating.
Water under high pressure!
Lingering in front of nozzle discharges could result in serious injuries.
Do not linger in front of nozzle discharges.
Never aim the nozzle at persons or equipment.
Before starting fire fighting, close all cabin doors and windows inside
the vehicle.
Danger of burns due to touching the hot pump system and hot water
discharge!
Operating the pump with closed discharge outlets causes the temperature
of the pump to rise quickly.
Do not operate pump under full load with discharge outlets closed.
Do not touch any parts of the hot pump system.
Do not linger in the pump system danger zone.
Danger to health due to extinguishing agents!
Observe the safety data sheets of the extinguishing agent
manufacturer.
To Next Page