Operation
- 35 -
Monitoring during operation
After switching off the ignition, the deactivation of the electric power supply
is initiated temporally delayed. The temporally delay can be extended up to
5 min, while all electronic systems power down.
For further information, please refer to the chassis manufacturers manual.
For electric power supply, keep the engine running during all operations.
6.3 Monitoring during operation
The pump control panel must be always in reach of the operator.
The LCS (Logic Control System) or Digiview monitors the:
• Water- and foam tank level.
• Fuel capacity, cooling water temperature, oil pressure etc.
In case of a fault, it will be shown on the screen and an audible warning sig-
nal sounds.
► The operator must take the appropriate measures, to avoid damages.
► In case of abnormal noises (e. g. cavitation, etc.) reduce engine speed
and respectively switch off the pump.
To Next Page
Loading...
Need help?
General