Feature Enhancements
A number of features have been added, or updated, to
this version of software. This section provides a brief
introduction to these features, and how to use them.
New Custom Controls
A number of custom controls have been added or
expanded.
RossTalk
Press Insert Event > More > RossTalk.
DescriptionCommand
Turn a GPI on or off.
• Press GPI and use the GPI knob to
select the GPI that you want to use.
• Press State and use the State knob
to select whether to turn the GPI on
(On or 1) or off (Off or 0).
GPI w/State
Audio Mixer
Press Insert Event > Special.
DescriptionCommand
Adjust the audio gain for a group. (Lawo
Ember+ only.)
1. Use the Group knob to select the
audio group that you want to adjust
the gain for.
2. Use the Level knob to select the new
gain level you want set for the group.
Audio Gain
New Personality Options
The following switcher personality options have been
added or changed.
Virtual Panel Positioner Reset
Allows you to specify whether the positioner on the
virtual panel returns to the neutral position automatically
(On), or if you have to click the positioner to have it
return to the neutral position (Off).
Press HOME > Setup > Personality and use the
Option knob to select Virt Panel Pos Reset.
• On — positioner returns to the neutral position after
0.5 seconds.
• Off — you must click on the positioner to have it
return to the neutral position.
Knob List Expansion
Allows the knob list you are scrolling to expand to the
full size of the area for a period of time. This allows you
to see more of the list at one time.
Press HOME > Setup > Personality and use the
Option knob to select Knob List Expansion.
• Rate — select the amount of time, in frames, that
the knob list stays expanded. Select 0 to have the list
not expand.
RossTalk Updates
The following commands have been added or updated.
Table 1: RossTalk Commands
DescriptionCommand
Set GPI xx to on (On or 1) or
off (Off or 0). For example,
GPI 04:Off sets GPI 4 to
off.
GPI xx:On/Off
Ultritouch
The 2RU rack mountable Ultritouch adaptable system
control panel allows you to control some aspects of
switcher operation using a DashBoard interface.
The DashBoard interface on Ultritouch provides control
over aux bus source selections. You must connect to the
switcher from Ultritouch to be able to control the switcher
functions. Refer to the Ultritouch documentation for
information on navigating the Ultritouch menu and
manually connecting to a device.
New Device Support
The following devices or commands/interfaces were
added or updated for this version of software.
New Devices
• Sony
®
BRC-1000
• Panasonic
®
AW-RP120
• Panasonic
®
AW-RP150
• Panasonic
®
AW-UE150
New/Updated Commands
• Send Loop Extra Option — an extra option has been
added to the AMP FlexClip driver to select whether
the switcher sends loop commands to the server.
Acuity UHD Configuration Guide (v9.1) — Feature Enhancements • 5
To Next Page
Loading...
