92 • DashBoard Interface Overview RCP-ME User Guide (v4.0)
Destination/Source Label Access Tabs
The Label Access tabs allow or deny a panel access to a label. Even if a button is assigned with a specific source or
destination label, and if the label access is denied (the box is unchecked), then a “
NoAcc” message is displayed if
the button is pressed.
Table 1 6. 11 summarizes the options displayed in the Destination/Source Label Access tabs.
Bottom Toolbar
The bottom toolbar provides the following buttons:
•
Refresh — click this button to revert to the configuration previously sent to the RCP-ME. The RCP-ME
Connection Editor will display the last settings that were sent to the RCP-ME via the Send Configuration button.
•
Send Firmware — click this button to open a file browser to select a software/firmware file to send to the
RCP-ME.
•
Send Configuration —click this button to upload the settings to the RCP-ME. All configuration items become
active only after uploading.
•
Reboot — click this button to reboot the RCP-ME. This function does not clear the RCP-ME settings.
•
Close — click this button to close the RCP-ME Connection Editor in DashBoard.
Send Configuration Dialog
The Send Configuration dialog is used to apply the changes made in DashBoard to the hard panel. The dialog is
divided into two areas:
• a column that lists the tabs that have unsent parameters
• the Select Devices list that enables you to specify which panels to send the new configuration to.
This dialog is displayed when the
Send Configuration button is clicked on the Panel Config interface.
Figure 16.8 Example of a Send Configuration Dialog
Table 16.11 Destination and Source Label Access Tabs
Item Parameters Description
# (read only) # table row number
Label (read-only) <text> displays the source or destination label as defined
by the Ultricore database or the Input/Output
assigns tab (if no Ultricore system)
Enabled Enable/disable access for this label
To Next Page
Loading...