Ross Ultricore RCP-ME - Page 91

RCP-ME User Guide (v4.0) DashBoard Interface Overview • 91
Salvo Names Tab
 Only applicable when the routing system includes an Ultrix router or Ultricore Central Controller.
The Salvo Names tab enables you to assign a new label, to be used only on this hard panel, to the salvos available
in the router database.
Table 16.9 summarizes the options displayed in the Salvo Names tab.
Level Names Tab
The Level Names tab enables you to assign a new label, to be used only on this RCP-ME, to the levels available in
the router matrix. You can also choose to enable or disable individual levels for this panel.
Table 16.10 summarizes the options displayed in the Level Names tab.
Output # Specifies the destination output
Input # Specifies the source input
Level Mask (1...32) # Specifies the level mask(s) for the device affected
by the macro
Clear Clear the level mask(s)
Set Set the level mask(s)
Table 16.9 Salvos Names Tab
Item Parameters Description
Salvo # (read-only) # Displays the list order number of the salvo
Name (read-only) <text> Name of the salvo as defined by the connected
Ultrix router or Ultricore Central Controller
Enabled This option is not implemented
Table 16.10 Level Names Tab
Item Parameters Description
# (read only) # Displays the list order number of the level name
entry
Name (read-only) <text> Displays the name of the Level as defined in
connected Ultrix router or Ultricore Central
Controller
Enabled Enable/disable this level in any Category mode
Table 16.8 Macro Events Tab
Item Parameters Description