Programming the AY-Q64
24 AY-Q64 Installation and Programming Manual
2. Press "3" to enter Menu 3.
The Transmit LED turns red.
3. Enter the new 4-digit code you wish to
set as the Programming code.
One beep is emitted on success.
The system returns to Transmit mode.
The Program LED turns off and the
Transmit LED remains red.
The Programming code cannot be erased; the code 0000 is not
valid and does not erase the Programming code.
6.6 14BChanging the Facility Code
To change the Facility code:
1. Enter Programming mode.
2. Press "4" to enter Menu 4.
The Transmit LED flashes orange.
3. Enter the new 3-digit code you wish to
set as the Facility code.
One beep is emitted on success.
The system returns to Transmit mode.
The Program LED turns off and the
Transmit LED turns red.
To Next Page
Loading...
Need help?
General
