Name: Rosslare AY-U920BT-US
Brand: Rosslare
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Operation Instructions

14 AY-U920BT-US Installation and User Manual

5. Operation Instructions

After wiring the unit to a controller (POWER, GND, D0, D1), you should test

the reader.

To test the reader:

1. Power up the reader. One beep is emitted and then it begins an auto-

calibration procedure. After 2 seconds, the reader enters working mode.

2. Present the appropriate type of credential to the reader. A short beep is

emitted, indicating that the credential is read properly.

Questions and Answers:

Need help?

Do you have a question about the Rosslare AY-U920BT-US and is the answer not in the manual?

Rosslare AY-U920BT-US Specifications

General