4
MAINTENANCE INSTRUCTIONS
WARNING
Monthly: Check cable. Adjust per instructions.
Monthly: Check level of runway. Adjust per instruc-
tions.
Monthly: Lubricate Guide on each turning radius with
a dry film lubricant. Clean and lubricate more often as
conditions warrant.
Semi-Annually: Check fluid level of lift power unit
and refill if required. If fluid is required, inspect all
fittings, hoses and seals. Repair as required.
Semi-Annually: Lubricate front wheel stop and ramp/
chock hinge pins.
Cable adjustment should be checked by
a Rotary Authorized Installer after the
first 50 loaded lift cycles and after 300 loaded lift cycles.
For Rolling Jack Maintenance Instructions see Rolling
Jack Installation, Operation and Maintenance Instruc-
tions in the rolling jack box.
WARNING
Replace if
bent
IMPORTANT
If you are not completely familiar with
automotive lift maintenance procedures,
STOP. Contact factory for instructions.
To Avoid Personal Injury, permit only qualified lift
service personnel to perform maintenance on this
equipment.
Periodically: Check all column, lift/runway attaching
bolts for tightness.
Always raise lift when cleaning floor area with solvents
and/or cleaning compounds.
Daily: Check cables and sheaves for wear. Replace
worn parts as required with genuine Rotary parts.
Daily: Inspect front wheel stops and ramp/chocks for
damage or excessive wear. Replace as required with
genuine Rotary parts.
Daily: Check locking latch operation and reset. Adjust
per instructions or repair if required with genuine
Rotary parts.
If slack cable arm is bent, Fig. 3, replace
immediately.
Weekly: Clean foreign debris from rear wheel slip
plates and turning radius gauges by blowing out with
shop air. DO NOT GREASE BALL BEARINGS.
Weekly: Check torque on the column anchor bolts per
specifications .
Fig. 3
To Next Page
Loading...
Need help?
General
