Rotary SM40 User Manual

8
* Perform check with and without a vehicle representative load.
REPAIR MAINTENANCE
(MAINTENANCE AUTHORIZED BY QUALIFIED SERVICE REPRESENTATIVE ONLY)
• Check accessibility of the operating procedures.
• Check accessibility and readability of all labels.
• Check the rated load capacity of the lift.
• Examine all structural components including welds.
• Check electrical cords for insulation damage.
• Check uid level.
• Check the lift controls for function.
• Check all fastening devices for tightness including oor anchor bolts.
• Check exposed surfaces and edges.
• Operate the lift and check the operation of the positive stop and the lift safety latches.
• With a representative vehicle on the lift, check the lowering speed (not to exceed 0.15 m/s).
• With a representative vehicle on the lift, check cable tension adjustment.
• Check the function of slack cable switches.
• Check all accessible piping, tubing, hose, valves and ttings. Review lift uid consumption records.
• Operate lift through full excursion and observe.
• With lift loaded, stop the lift at midpoint of travel and observe for drifting down and hydraulic leaks.
• Check with operator to ascertain any unusual operating characteristics.
*
Inspection Points
• Lockout any energy sources before beginning
any repairs.
•DONOT modify the lift in any manner without the
prior written consent of the manufacturer.
• If electrical problems develop, make repairs ac-
cording to local electrical codes. Use genuine
Rotary Lift parts when replacement is necessary.
• Replace worn parts as required with genuine
Rotary parts.
• Cable adjustment should be checked by a Rotary
Authorized Installer after the rst 50 loaded lift
cycles and after 300 loaded lift cycles.
• Adjust cable tension per lift installation instruc-
tions.
• Monthly: Lubricate locking latch shafts. Activate
latches several times for oil to penetrate joints.
Aside from the routine checks that are stated under "Operator Maintenance", the following annual inspec-
tion is to be performed and a record of this inspection permanently retained on site. All deficiencies are
to be corrected by the proper authorized personnel.
Annual Inspection
(performed by Authorized Personnel)

Rotary SM40 Specifications

General

Brand	Rotary
Model	SM40
Category	Lifting Systems
Language	English