Rotary SM40 - Maintenance Instructions

7
TROUBLE SHOOTING (for OPERATORS)
Remedy
1. Replace blown fuse or reset circuit
breaker.
2. Contact service representative for
further assistance.
1. Fill tank with Dexron III ATF
or equivalent.
2. Contact service representative for
further assistance.
1. Check vehicle weight and/or
balance vehicle weight on lift.
2. Contact service representative for
further assistance.
Contact service representative for
further assistance.
Contact service representative for
further assistance.
Contact service representative for
further assistance.
Contact service representative for
further assistance.
Contact service representative for
further assistance.
Contact service representative for
further assistance.
Blown fuse or circuit breaker.
Low fluid level.
Overloading lift.
See Remedy
See Remedy
See Remedy
See Remedy
See Remedy
See Remedy
Motor does not run.
Motor runs but will not raise lift.
Motor runs—raises unloaded lift but
will not raise vehicle.
Lift slowly settles down.
Slow lifting speed or fluid blowing
out filler breather cap.
Lift going up unlevel.
Anchors will not stay tight.
Locking latches do not engage.
Locking latches do not disengage.
Trouble
Cause