Rotary SPOA3T Series - Operator Inspection & Maintenance

7
• Always keep bolts tight. Check periodically.
• Alwaysassurearmstopboltsareinplace.
• Alwayskeepliftcomponentsclean.
• Always, if oil leakage is observed, call local service
representative.
• Daily: Check cables and sheaves for wear. If parts are worn,
call local service representative.
• Daily:Inspectadaptersfordamageorexcessivewear.If
parts are worn, call local service representative.
• Daily:Checkforpermanentdeformationtothelatches.If
present, call local service representative to replace parts.
• Monthly:Checkequalizercabletension.Ifpartsareworn,
call local service representative.
• Monthly: Check overhead sensor for function.
• Monthly:Cleanandcheckbaseoflift.Removeanyrustand
touch-up with paint.
• Every 3 Months: Check anchor bolts for tightness. Anchors
shouldbetorquedto200Nm(12.4kg-m).
• Every 6 Months:Checkuidlevelofliftpowerunitandrell
to proper level in level indicator with lift fully lowered.
• Replacealldecalsontheliftifunabletoreadormissing.
ReorderlabelsfromRotaryLift.
OPERATOR INSPECTION & MAINTENANCE
(MAINTENANCE AUTHORIZED BY OPERATOR)