INSTALLATION MANUAL
AIRCRAFT ENGINES
page 8 - 2
Initial issue, May 01/99
Effectivity: 447 UL SCDI, 503 UL DCDI, 582 UL DCDI /mod. 99
d00318
8.2) Protective covering
All openings are protected against ingress of contamination and dampness. It is
recommended not to remove these plugs until installation of the specific feed line.
◆ NOTE: If the engine will be sent to the manufacturer or distributor reuse
transport equipment and replug openings.
List of protective covering:
☞ carburetor inlet: ............................................................. 1 each cover
☞ fresh oil pump: ............................................................... 1 plug
☞ vent screw, gearbox:..................................................... 1 cap
☞ exhaust:......................................................................... adhesive tape
▲ WARNING: Protective covering to be utilized for transport and at engine
installation only. All shipping and preservation devices must be
removed prior to engine operation.
To Next Page
Loading...
