Rotax 912 i series

To Next Page

To Previous Page

d07068.fm

SI-912 i-029 / SI-915 i-012

SI-916 i-007

SERVICE INSTRUCTION

08 February 2024 74-20-00

Initial Issue Page 11 of 15

3.5.4) Double ignition coil - installation

1 Protection hose

2 Ignition cable

3 Protective cap

4 Threaded prong

Fig. 8

Double ignition coil

Measurement

Figure

Measuring points Resistance

Primary side 0.5 Ω +/- 0.5 Ω

Secondary side 9 kΩ +/- 0.9 kΩ

Between primary

and secondary side

Infinite

See current Maintenance Manual Heavy (MMH) for the respective engine type, Chapter

74-20-00.

Step Procedure

1 Screw ignition cable clockwise into coil.

2 Slide rubber seal over coil.

3 Place the appropriately marked protection hose over the ignition cable.

Rotax 912 i series - Page 11