d06703.fm
03 July 2019 76-10-00
Initial Issue Page 14 of 18
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
SI-912 i-024
SI-915 i-006
SERVICE INSTRUCTION
Assembly of the connector housing Amphenol® part no. 864590
Place numbered wires in the following alphabetical positions:
Fig. 16
Step Procedure
1 Place rear connector screw cap over wires (13).
2
Push connector pins and wires through round rubber seal (14).
NOTE: New connector positions are marked A through D (15), whereas the gray
housing was marked 1 through 4.
Wire Connector position
1A
2B
3C
Step Procedure
3 Place plastic sleeve over wires with key slot (16) towards connector.
Step Procedure
4
Push each wire into connector until its pin snaps securely in place.
NOTE: Correctly secured pins will travel further into connector (18) and lock in
place. Removal requires using extractor tool.
13 Screw cap
14 Rubber seal
15 Position letters
16 Key slot
To Next Page
Loading...
