d06703.fm
SI-912 i-024
SI-915 i-006
SERVICE INSTRUCTION
03 July 2019 76-10-00
Initial Issue Page 15 of 18
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
Fig. 17
Fig. 18
Step Procedure
5
With all connector pins secured, place the plastic ring into the connector housing,
while aligning the keyway.
6 Push the rubber seal into the plastic ring and screw on connector cap (20).
7 Place plastic sealing plug into empty position in rear seal (21).
17 Example for secured pin
18 Example for un-secured pin
To Next Page
Loading...
