Effectivity: 914 Series BRP-Powertrain page 3-8
OM Edition 2 / Rev. 0 April 01/2010
d04475.fm
To observe! Reduction gear with shock absorber
9 Oil pressure Check if oil pressure has ri-
sen within 10 seconds and
monitor oil pressure. Increa-
se of engine speed is only
permitted at steady oil pres-
sure readings above 2 bar
(30 psi).
10 At an engine start with low oil tempera-
ture, continue to observe the oil pres-
sure as it could drop again due to the
increased flow resistance in the suction
line. The engine speed rpm may be only
so far increased that the oil pressure re-
mains steady.
11 Staring carb De-activate.
Step Designation Procedure
Since the engine comprises a reduction gear
with shock absorber, take special care of the
following:
Step Procedure
1
To prevent impact load, start with throttle lever in idle
position or at the most up to 10% open.
2
For the same reason, wait for around 3 sec. after
throttling back to partial load to reach constant speed
before re-acceleration.
3
For checking the two ignition circuits, only one circuit
may be switched off and on at a time.
To Next Page
Loading...
Need help?
General
