Rotax 915 i A SERIES Service Instructions

d06703.fm
03 July 2019 76-10-00
Initial Issue Page 8 of 18
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
SI-912 i-024
SI-915 i-006
SERVICE INSTRUCTION
Fig. 4
Fig. 5
Step Procedure
4
Place the connector pin into crimp tool with crimp-barrel facing outwards. Adjust po-
sitioner until crimp-barrel protrudes approximately 1 to 2 mm (0.039 in. to 0.08 in.)
from the tool face (10).
5
Place stripped wire fully into crimp-barrel and hold in place while crimp tool is com-
pressed by hand until fully closed.
NOTE: Crimp tool incorporates a ratcheting mechanism that requires the crimp
tool to be fully closed before releasing.
Step Procedure
6
Remove the wire and crimped connector pin from crimp tool and inspect for correct
crimping.
NOTE: Wire strands must be visible in witness hole (11) and crimps must be
between the witness hole and the end of the crimp-barrel (12).
8 12 AWG (3.31 mm
2
)
9 1 mm (0.039 in.)
10 Tool face 1 - 2 mm
(0.039 in to 0.08 in.)

Rotax 915 i A SERIES Specifications

General

Brand	Rotax
Model	915 i A SERIES
Category	Engine
Language	English