Rotec Versatech 1100 - Pre-Use Bed Verification

16
3.2 Verification before starting to use the bed
These verifications are necessary to make sure that the bed was not damaged during
transport:
 Inspect the bed and its accessories visually;
 Inspect the head and foot boards installation (refer to section 2.1);
 Verify the functioning of the side rails and their locking mechanisms;
 Apply the brakes of the casters and check their functioning (refer to section 3.9.3);
 Plug the power cable and activate all the motors. Check if their functioning is
constant and complete. This verification also allows you to check the functioning of
the remote control (refer to section 3.3.1);
 Unplug the power cable and turn on the motors to check the battery.
NOTE : Plug the bed for 48 hours consecutively to charge the battery before doing
this verification;
 Verify the locking functions of the nurse control by activating them and trying to use
the functions of the remote control. Verify also that the commands on the nurse
control work properly by activating them (refer to section 3.3.2);
 Verify the patient control integrated to the side rails (option) by activating them (refer
to section 3.3.3)
 Verify the functioning of the CPR function (electric) with a mattress and with
someone leaning back against the backrest. Proceed carefully (refer to section
3.9.2).
If the bed is damaged or does not work properly, contact Rotec International customer
service.