3.9.3 Casters with synchronized brake system
To facilitate access to the brake system, it is recommended to raise the height of
the bed to at least 150mm (6 in) from the lowest position.
To activate the brake system, position the pedal in one of the three following
positions:
To start the directional To remove any restriction To apply the brakes:
mode and to allow the bed and to allow the bed to
to move in a straight line: move in any direction:
push down on put the pedal push down on the red side
the green side of the pedal. horizontally. of the pedal.
* Do not move the bed sideways when the directional mode is on. This will avoid
injuries to the user and the personnel..
3.9.4 Chair position
This function place the bed in reverse Trendelenburg position, increase the angle of the
back and thighs section simultaneously.
Activate this function as follow:
- Press on the button on the nurse control (refer to section 3.3.2) and maintain it until
the bed is in the chair position. (require around 60 seconds)
To Next Page
Loading...