Technical
Manual
STEREO INTEGRATED AMPLIFIER
RA-1060
Table of Contents
Specification
Specification...................................... 1
Parts List ........................................... 2~3
Adjustment........................................ 4
Safety Caution................................... 4
Case Outlines.................................... 5
PCB Assembly .................................. 7~8
Schematic Diagram .......................... 9~12
Continuous Power Output 60 watts/channel
(20 - 20 kHz, < 0.03%, 8 ohms)
Total Harmonic Distortion (20 Hz - 20 kHz) < 0.03% at rated power, 1/2 power, or 1 watt
Intermodulation Distortion(60 Hz : 7 kHz, 4:1) < 0.03% at rated power, 1/2 power or 1 watt
Frequency Response (all inputs) 10 Hz - 100 kHz, +l, -3dB
Damping Factor (20 - 20,000 Hz. 8 ohms) 150
Input Sensitivity / impedance 160 mV / 33 kOhms
Input Overload 5 v
Preamplifier Output / Impedance 1 V / 470 ohms
Signal to Noise Ratio (IHF " A" weighted) >95 dB
Power Requirements USA: 115 Volts, 60 Hz
EC: 230 Volts, 50 Hz
Power Consumption 300 Watts
Dimensions (W x H x D) 430 x 92 x 355 mm
17 x5
5/8
x 14 inches
Weight (net) 7.8 kg, 17.2 lbs.
SHINSEN-BLD. 4F 10-10 SHINSEN-CHO, SHIBUYA-KU,
TOKYO 150-0045, JAPAN
Serial. NO.
Beginning
®
Quality Uncompromised
Y-332A-00115C/S-S
To Next Page
Need help?
General
